Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1304

Version 9.9(0.0) 9.0.2.0 8.3.19.0 8.3.7.0 7.8.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the C-Series. Introduced on the E-Series. Usage Information This feature allows you to limit the number of multicast entries on the system. This number is the total of all the multicast entries on all line cards in the system. On each line card, the multicast module only installs the maximum number of entries, depending on the configured CAM profile. To store multicast routes, use the IN-L3-McastFib CAM partition. It is a separate hardware limit that exists per port-pipe. This hardware space limitation can supersede any software-configured limit. The opposite is also true, the CAM partition might not be exhausted at the time the system-wide route limit set by the ip multicast-limit command is reached. Related Commands show ip igmp groups - shows the IGMP groups. ip multicast-routing Enable IP multicast forwarding. C9000 Series Syntax ip multicast-routing To disable multicast forwarding, use the no ip multicast-routing command. Defaults Disabled. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 Description Introduced on the C9010. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. 1304 Multicast