Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 947

Version 7.5.1.0 Description Introduced on the C-Series. Usage Information The shutdown command marks a physical interface as unavailable for traffic. To discover if an interface is disabled, use the show ip interface brief command. Disabled interfaces are listed as down. Disabling a VLAN or a port channel causes different behavior. When a VLAN is disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic continues to flow. Entering the shutdown command on a port channel disables all traffic on the port channel and the individual interfaces within the port channel. To enable a port channel, enter no shutdown on the port channel interface and at least one interface within that port channel. The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port channel. Related Commands interface port-channel - creates a port channel interface. interface vlan - creates a VLAN. show ip interface - displays the interface routing status. Add the keyword brief to display a table of interfaces and their status. speed (Management interface) Set the speed for the Management interface. C9000 Series Syntax speed {10 | 100 | auto} To return to the default setting, use the no speed {10 | 100} command. Parameters 10 100 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Enter the keyword 100 to set the interface's speed to 10/100 Mb/s. Enter the keyword auto to set the interface to autonegotiate its speed. Defaults auto Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. Interfaces 947