Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 326

Related Commands NOTE: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. deny - configures a MAC ACL filter to drop packets. seq - configure a MAC ACL filter with a specified sequence number. seq Configure a filter with a specific sequence number. C9000 Series Syntax seq sequence-number {deny | permit} {any | host mac-address | mac-source-address mac-source-address-mask} {any | host macaddress | mac-destination-address mac-destination-address-mask} [ethertype operator] [count [byte]] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To delete a filter, use the no seq sequence-number command. Parameters sequencenumber Enter a number as the filter sequence number. The range is from zero (0) to 65535. deny Enter the keyword deny to drop any traffic matching this filter. permit Enter the keyword permit to forward any traffic matching this filter. any Enter the keyword any to filter all packets. host mac-address Enter the keyword host and then enter a MAC address to filter packets with that host address. mac-sourceaddress Enter a MAC address in nn:nn:nn:nn:nn:nn format. The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that match exactly. mac-sourceaddress-mask mac-destinationaddress mac-destinationaddress-mask Specify which bits in the MAC address must be matched. Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format. Specify which bits in the MAC address must be matched. 326 Access Control Lists (ACL)