Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1278

Related Commands Version 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. protocol lldp (Configuration) - enables LLDP globally. debug lldp interface - debugs LLDP. show lldp neighbors - displays the LLDP neighbors. show running-config lldp - displays the LLDP running configuration. hello Configure the rate at which the LLDP control packets are sent to its peer. C9000 Series Syntax hello seconds To revert to the default, use the no hello seconds command. Parameters seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The rate is from 5 to 180 seconds. The default is 30 seconds. Defaults 30 seconds Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. 1278 Link Layer Discovery Protocol (LLDP)