Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1608

source mask any host ip-address destination operator • syn = synchronize sequence number • urg = urgent field Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for theport command parameter.) Defaults none Command Modes REDIRECT-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 8.4.2.0 7.7.1.0 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Added support for the track-id on the S4810, S4820T, S6000, and Z9000. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series TeraScale. Introduced on the E-Series ExaScale. 1608 Policy-based Routing (PBR)