Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2077

Version 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command and enter no disable. Related Commands virtual-address - specifies the IP address of the virtual router. hold-time Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the new switch can stabilize its routing tables. C9000 Series Syntax hold-time {seconds | centisecs centisecs} To return to the default value, use the no hold-time command. Parameters seconds centisecs centisecs Enter the number of seconds. The range is from 0 to 65535. The default is zero (0) seconds. Enter the keyword centisecs then the number of centisecs in units of 25 centisecs . The range is from 0 to 65525 in units of 25 centisecs. Defaults zero (0) seconds or or (0) centiseconds Command Modes VRRP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.5(0.0) 9.2(1.0) 9.0.2.0 Description Introduced on the C9010. Added support for centisecs on the Z9500. Added support for centisecs on the Z9000, S6000, S4820T, S4810, and MXL. Introduced on the Z9500. Introduced on the S6000. Virtual Router Redundancy Protocol (VRRP) 2077