Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 80

Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands. To protect against unauthorized access, use the enable password command to configure a password for the enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15. You can also use the enable [level] command from a PE console to enter the privileged mode. NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an enable password. Related Commands enable password - configures a password for the enable command and to access a privilege level. enable optic-info-update interval Enable polling intervals of optical information updates for simple network management protocol (SNMP). C9000 Series Syntax enable optical-info-update interval seconds To disable optical power information updates, use the no enable opticalinfo-update interval command. Parameters interval seconds Enter the keyword interval then the polling interval in seconds. The range is from 120 to 6000 seconds. The default is 300 seconds (5 minutes). Defaults Disabled Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.4 Description Introduced on the C9010. Introduced on the Z9500. Replacement command for the S4820T. Replaces the enable xfp-power-updates command. Replacement command for the Z9000. Replaces the enable xfp-power-updates command 80 Control and Monitoring