Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 460

Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 7.8.1.0 7.7.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series. neighbor timers Set keepalive and hold time timers for a BGP neighbor or a peer group. C9000 Series Syntax neighbor {ip-address | peer-group-name} timers keepalive holdtime To return to the default values, use the no neighbor {ip-address | peergroup-name} timers command. Parameters ip-address Enter the IP address of the peer router in dotted decimal format. peer-group-name Enter the name of the peer group to set the timers for all routers within the peer group. keepalive Enter a number for the time interval, in seconds, between keepalive messages sent to the neighbor routers. The range is from 1 to 65535. The default is 60 seconds. holdtime Enter a number for the time interval, in seconds, between the last keepalive message and declaring the router dead. The range is from 3 to 65535. The default is 180 seconds. Defaults • keepalive = 60 seconds • holdtime = 180 seconds Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 460 Border Gateway Protocol