Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1432

Usage Information You must have an IP address assigned to an interface to enter ROUTER OSPF mode and configure OSPF. After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID again in the system. You can only create one process per VRF. Example To create an OSPF instance in default vrf Dell(conf)#router ospf 1 Dell(conf-router_ospf-1)# To create an OSPF instance in a non-default vrf, for example, "vrf1" Dell(conf)#router ospf 2 vrf vrf1 Dell(conf-router_ospf-2)# show config Display the non-default values in the current OSPF configuration. C9000 Series Syntax show config Command Modes ROUTER OSPF Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell(conf-router_ospf)#show config ! router ospf 3 passive-interface FastEthernet 0/1 Dell(conf-router_ospf)# 1432 Open Shortest Path First (OSPFv2 and OSPFv3)