Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1490

ipv6 ospf cost Explicitly specify the cost of sending a packet on an interface. C9000 Series Syntax Parameters ipv6 ospf interface-cost interface-cost Enter a unsigned integer value expressed as the link-state metric. The range is from 1 to 65535. Defaults Default cost based on the bandwidth. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.1.(0.0) 7.8.1.0 7.4.1.0 8.3.19.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4810 and Z9000. Added support for C-Series. Introduced on the E-Series. Introduced on the S4820T. Usage Information In general, the path cost is calculated as: 10^8 / bandwidth Using this formula, the default path cost is calculated as: • 10-Gigabit Ethernet-Default cost is 1 • 40-Gigabit Ethernet - Default cost is 1 ipv6 ospf dead-interval Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare the router down. C9000 Series Syntax ipv6 ospf dead-interval seconds 1490 Open Shortest Path First (OSPFv2 and OSPFv3)