Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1197

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a Null interface, enter the keyword null then the Null interface number. • For a tunnel interface, enter the keyword tunnel then the tunnel interface number. The range is from 1 to 16383. • For a VLAN interface, enter the keyword VLAN then the vlan number. The range is from 1 to 4094. If you configure a static IPv6 route using an egress interface and enter the ping command to reach the destination IPv6 address, the ping operation may not work. Configure the IPv6 route using a next-hop IPv6 address in order for the ping command to detect the destination address. ipv6-address Enter the forwarding router IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. distance tag value permanent (OPTIONAL) Enter a number as the metric distance assigned to the route. The range is from 1 to 255. (OPTIONAL) Enter the keyword tag then a tag value number. The range is from 1 to 4294967295. (OPTIONAL) Enter the keyword permanent to specify that the route is not to be removed, even if the interface assigned to that route goes down. NOTE: If you disable the interface with an IPv6 address associated with the keyword permanent, the route disappears from the routing table. weight weightvalue Enter the keyword weight followed by a weight value. The range is from 0 to 255. NOTE: Weight for a static route can be added only for the destination address and not for the route pointing to destination a interface. vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to install IPv6 routes in that VRF. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. IPv6 Basics 1197