Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 883

Example (Single Range) Related Commands This example shows how to define an interface range macro named test. Execute the show running-config command to display the macro definition. Dell(config)# define interface-range test tengigabitethernet 0/0-3, tengigabitethernet 1/0-47, tengigabitethernet 2/0-89 Dell# show running-config | grep define define interface-range test tengigabitethernet 0/0-3, tengigabitethernet 1/0-47, tengigabitethernet 2/0-89 Dell(config)#interface range macro test Dell(config-if-range-te-0/0-3,te-1/0-47,te-2/0-89)# • interface range - configures a range of command (bulk configuration) • interface range macro name - runs an interface range macro. interface range macro name Run the interface-range macro to automatically configure the pre-defined range of interfaces. C9000 Series Syntax Parameters interface range macro name name Enter the name of an existing macro. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Interfaces 883