Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1530

39 PE Stacking Use the commands in this chapter to configure and manage C1048P port-extender (PE) stacking. Stacking is not supported on C9010 switches. For information about using the PE stacking feature, see the "Port Extender (PE) Stacking" chapter in the Dell Networking OS Configuration Guide for the C9000 Series. You can use the commands to pre-configure a port extender, so that the configuration settings are invoked when the switch is attached to the chassis. renumber To rearrange the stack units, reassign a stack unit ID number. C9000 Series Syntax Parameters pe pe-id stack-unit unit number renumber unit number pe pe-id stack-unit unit number renumber unit number Enter the keyword pe and the PE ID. The range is from 0 to 255. Enter the keyword stack-unit and the stack-unit ID number. The range is from 0 to 7. Enter the keyword renumber and a new stack-unit ID number. The range is from 0 to 7. Default Default stack-unit number is zero. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command-Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. Example Dell# pe 255 stack-unit 0 renumber 2 1530 PE Stacking