Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1063

ip igmp ssm-map To translate (*,G) memberships to (S,G) memberships, use a statically configured list. C9000 Series Syntax ip igmp ssm-map std-access-list source-address Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) state, use the ip igmp ssm-map std-access-list sourceaddress command. Parameters std-access-list source-address Specify the standard IP access list that contains the mapping rules for multicast groups. Specify the multicast source address to which the groups are mapped. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Version 9.5(0.0) Version 9.0.2.0 Version 8.3.19.0 Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may not use extended access lists with this command. When you configure a static SSM map and the router cannot find any matching access lists, the router continues to accept (*,G) groups. Related Commands ip access-list standard - creates a standard access list to filter based on IP address. Internet Group Management Protocol (IGMP) 1063