Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 264

StartingSeqNum Step-toIncrement Enter the starting sequence number to resequence. The range is from 0 to 65535. Enter the step to increment the sequence number. The range is from 1 to 65535. Defaults none Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the E-Series ExaScale Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information When you have exhausted all the sequence numbers, this feature permits reassigning a new sequence number to entries of an existing prefix list. Related Commands resequence access-list - resequences an access-list. seq Assign a sequence number to a deny or permit filter in an IP access list while creating the filter. C9000 Series Syntax seq sequence-number {deny | permit} {source [mask] | any | host ip-address}} [count [bytes]] [dscp value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To delete a filter, use the no seq sequence-number command. 264 Access Control Lists (ACL)