Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 894

Example Example (Vlan) Related Commands Dell(conf-if-vl-10)# untagged te 2/0 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# tagged te 2/0 Dell(conf-if-vl-20)# Dell(conf-if-vl-20)# do show interfaces switchport Name: TenGigabitEthernet 2/0 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 Dell(conf-if-vl-20)# Dell(conf-if-vl-20)# interface vlan 10 Dell(conf-if-vl-10)# no untagged te 2/0 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# no tagged te 2/0 Dell(conf-if-vl-20)# interface te 2/0 Dell(conf-if-te-2/0)# no portmode hybrid Dell(conf-if-vl-20)# • show interfaces switchport - displays the configuration of switchport (Layer 2) interfaces on the switch. • switchport - places the interface in a Layer 2 mode. • vlan-stack trunk - specifies an interface as a trunk port to the Stackable VLAN network. rate-interval Configure the traffic sampling interval on the selected interface. C9000 Series Syntax Parameters rate-interval seconds seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299 seconds. NOTE: Because polling occurs every 15 seconds, the number of seconds designated here rounds to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59 seconds rounds to 45. Defaults 299 seconds Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 894 Interfaces