Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1092

The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.2.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid. Related Commands clear arp-cache - clears dynamic ARP entries from the ARP table. show arp - displays the ARP table. arp backoff-time Set the exponential timer for resending unresolved ARPs. C9000 Series Syntax Parameters arp backoff-time seconds / minutes seconds minutes Enter the number of seconds an ARP entry is black-holed. The range is from 1 to 3600. The default is 30 minutes. Enter the number of minutes an ARP entry is balck-holed. The range is from 0 to 35790. The default is 4 hours. Defaults 30 Command Mode CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. 1092 IPv4 Routing