Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1080

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383. • For a port channel interface, enter the keywords portchannel then a number. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. detail (OPTIONAL) Enter the keyword detail to display the IGMPv3 source information. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.7(0.1) 9.7(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S4810, S4820T, S5000, S6000, Z9000, and Z9500. Usage Information This command displays the IGMP database, including configured entries for either all groups on all interfaces, all groups on specific interfaces, or specific groups on specific interfaces. The following describes the show ip igmp groups command shown in the following example. Field Group Address Interface Mode Uptime Expires Last Reporter Description Lists the multicast address for the IGMP group. Lists the interface type, slot and port number. Displays the IGMP version used. Displays the amount of time the group has been operational. Displays the amount of time until the entry expires. Displays the IP address of the last host to be a member of the IGMP group. 1080 Internet Group Management Protocol (IGMP)