Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 99

Parameters address) | interface] [tos] [df-bit (y|n)] [validate-reply(y| n)] [outgoing-interface] [pattern pattern] [sweep-min-size] [sweep-max-size] [sweep-interval] [ointerface (ip src-ipv4address) | interface] host ip-address ipv6-address count (OPTIONAL) Enter the host name of the devices to which you are testing connectivity. (OPTIONAL) Enter the IPv4 address of the device to which you are testing connectivity. The address must be in the dotted decimal format. (OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity. NOTE: The :: notation specifies successive hexadecimal fields of zeros. Enter the number of echo packets to be sent. The default is 5. • number: from 1 to 2147483647 • continuous: transmit echo request continuously datagram size timeout source Enter the ICMP datagram size. The range is from 36 to 15360 bytes. The default is 100. Enter the interval to wait for an echo reply before timing out. The range is from 0 to 3600 seconds. The default is 2 seconds. Enter the IPv4 or IPv6 source ip address or the source interface. For IPv6 addresses, you may enter global addresses only. Enter the IP address in A.B.C.D format. • For a Port Channel interface, enter the keyword portchannel then a number: The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a Tunnel interface, enter the keyword tunnel then a number from 1 to 16383. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. tos df-bit (IPv4 only) Enter the type of service required. The range is from 0 to 255. The default is 0. (IPv4 only) Enter Y or N for the "don't fragment" bit in IPv4 header. • N: Do not set the "don't fragment" bit. Control and Monitoring 99