Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2090

• For a 40-Gigabit Ethernet interface, enter the keyword FortyGigE followed by the slot/port information. • For a tunnel interface, enter the keyword tunnel followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN ID range is from 1 to 4094. • For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE followed by the pe-id /stack-unit unit number / port-ID number. priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority value. The range is 1 to 254. The default is 10. Defaults priority cost = 10 Command Modes VRRP Command History Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.2.(1.0) 9.0.2.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S-Series (S50 only). Introduced on the C-Series. Introduced on the E-Series. Usage Information If the interface is disabled, the cost value is subtracted from the priority value and forces a new MASTER election if the priority value is lower than the priority value in the BACKUP virtual routers. IPv6 VRRP Commands The following are IPv6 VRRP commands. • clear counters vrrp ipv6 • debug vrrp ipv6 • show vrrp ipv6 • vrrp-ipv6-group The following commands apply to IPv4 and IPv6: 2090 Virtual Router Redundancy Protocol (VRRP)