Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2102

NOTE: You must use the route-map attribute while importing routes from the global RTM. Route-maps enable you to filter routes at the import end based on the matching criteria that you define in the route-map. Defaults Command Modes Not configured. • CONFIGURATION • VRF MODE Command History Version 9.9(0.0) 9.8(0.0) 9.7(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S4810, S4820T, S5000, S6000, S6000- ON, and Z9500. Usage Information You can configure multiple import conditions per VRF depending on the exporting VRF. The export-target and import-target support only the match protocol and match prefix-list options, all other options configured in the route-map are ignored. Related Commands ip route-export - exports routes to another VRF. ipv6 route-export Enable route leaking between VRFs. Export or share IPv6 routes corresponding to one VRF with other non-default VRFs. C9000 Series Syntax Parameters ipv6 route-export tag [route-map-name] route-export tag route-map-name Enter the keyword route-export to leak or share routes between VRFs. Enter a tag (ASN number) as the export route target to expose routes to other VRFs. This tag acts as an identifier for exported routes. You can use this identifier while importing these routes into another non-default VRF. (Optional) Enter the name of the route-map to filter the exported routes. You can leak global routes to be made available to VRFs. As the global RTM usually contains a large 2102 Virtual Routing and Forwarding (VRF)