Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1647

power inline Enable inline power and configure maximum power allocation with priority for the powered device connected to an interface. C9000 Series Syntax power inline {[max_milliwatts ]| priority {critical | high | low}} To disable a device that has been enabled for PoE power supply, use the no power inline command. Parameters max_milliwatts (OPTIONAL) Specify the maximum amount of inline power allocation to a powered device connected to the interface. Range is 440-30000 milliwatts (mWs). The default value is 30000 mWs. NOTE: The max_milliwatt configuration is effective only in Static mode. priority critical high low Enter the keyword priority to specify the PoE priority for the powered device connected to the interface. Default priority value is low. Enter the keyword critical to set the PoE priority level as critical. Enter the keyword high to set the PoE priority level as high. Enter the keywordlow to set the PoE priority as low. Defaults Default priority is low. Command Modes INTERFACE CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. Usage information The power inline [max_milliwatts} command enables inline power supply to an interface. You can specify the maximum amount of power allocation to a device in max-milliwatts, within a range of 440-30000 mW. If a specific power supply value is not configured, the default value of 30,000 mW is configured as the maximum power for allocation to powered devices. You can disable the inline power supply to a port using the no power inline command. Port Extenders (PE) 1647