Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 877

Version 8.3.19.0 8.3.11.1 8.3.11.1 8.1.1.0 7.5.1.0 6.4.1.0 Description Introduced on the S4820T. Introduced on the Z9000. Introduced on the S55, S60, and S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series. Introduced Usage Information You cannot delete a Management port. The Management port is enabled by default (no shutdown). To assign an IP address to the Management port, use the ip address command. If your system has two RPMs installed, use the show redundancy command to display which RPM is the Primary RPM. Example Related Commands Dell(conf)# interface managementethernet 0/0 Dell(conf-if-ma-0/0)# management route - configures a static route that points to the Management interface or a forwarding router. duplex (Management) - clears the forwarding information base (FIB) entries on a specified line card. speed (Management interface) - clears the FIB entries on a specified line card. interface null Configure a Null interface on the switch. C9000 Series Syntax Parameters interface null number number Enter zero (0) as the Null interface number. Defaults Not configured; number = 0 Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Interfaces 877