Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1887

52 Service Provider Bridging Service provider bridging is composed of virtual local area network (VLAN) Stacking, Layer 2 Protocol Tunneling, and Provider Backbone Bridging as described in the Dell Networking OS Configuration Guide Service Provider Bridging chapter. This chapter includes command line information (CLI) for the Dell Networking operating software Layer 2 Protocol Tunneling (L2PT). L2PT enables protocols to tunnel through an 802.1q tunnel. For more information, refer to VLAN Stacking, Spanning Tree Protocol (STP), and GARP VLAN Registration (GVRP). Important Points to Remember • L2PT is enabled at the interface VLAN-Stack VLAN level. For more information about Stackable VLAN (VLAN-Stacking) commands, refer to VLAN Stacking. • The default behavior is to disable protocol packet tunneling through the 802.1q tunnel. • Rate-limiting is required to protect against bridge protocol data units (BPDU) attacks. • A port channel (including through link aggregation control protocol [LACP]) can be configured as a VLAN-Stack access or trunk port. • Address resolution protocol (ARP) packets work as expected across the tunnel. • Far-end failure detection (FEFD) works the same as with Layer 2 links. • Protocols that use Multicast MAC addresses (for example, open shortest path first [OSPF]) work as expected and carry over to the other end of the VLAN-Stack VLAN. debug protocol-tunnel Enable debugging to ensure incoming packets are received and rewritten to a new MAC address. C9000 Series Syntax debug protocol-tunnel interface {in | out | both} [vlan vlanid] [count value] To disable debugging, use the no debug protocol-tunnel interface {in | out | both} [vlan vlan-id] [count value] command. Service Provider Bridging 1887