Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1062

Usage Information If you have configured the hello interval value to be greater than 18000, you must first reset that value to be less than or equal to 18000 before upload. Otherwise, the command execution fails during bootup and the hello interval value is set to the default value. ip igmp query-max-resp-time Set the maximum query response time advertised in general queries. C9000 Series Syntax ip igmp query-max-resp-time seconds To return to the default values, use the no ip igmp query-max-resp-time command. Parameters seconds Enter the number of seconds for the maximum response time. The range is from 1 to 25. The default is 10 seconds. Defaults 10 seconds Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.2(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 7.6.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the S-Series in Interface VLAN mode only to enable the system to act as an IGMP Proxy Querier. Introduced on the C-Series in Interface VLAN mode only to enable the system to act as an IGMP Proxy Querier. 1062 Internet Group Management Protocol (IGMP)