Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 457

Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 7.8.1.0 7.7.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series. Usage Information To configure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode. Before using this command, you must execute the clear ip bgp command. neighbor shutdown Disable a BGP neighbor or peer group. C9000 Series Syntax neighbor {ip-address | peer-group-name} shutdown To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-name} no shutdown command. Parameters ip-address Enter the IP address of the neighbor in dotted decimal format. peer-group-name Enter the name of the peer group to disable or enable all routers within the peer group. Defaults Enabled (that is, BGP neighbors and peer groups are disabled.) Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Border Gateway Protocol 457