Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2089

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. Related Command virtual-address - assigns up to 12 virtual IP addresses per VRRP group. track Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled. C9000 Series Syntax track interface [priority-cost cost] To disable monitoring, use the no track interface command. Parameters interface OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a Port Channel interface, enter the keywords portchannel followed by the number. The range of portchannel IDs is 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For SONET interfaces, enter the keyword sonet followed by the slot/port information. Virtual Router Redundancy Protocol (VRRP) 2089