Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1561

Defaults 1 Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.7(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 Description Introduced on the C9010. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series on port-channels and the SSeries. Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router. ip pim neighbor-filter To prevent a router from participating in protocol independent multicast (PIM), configure this feature. C9000 Series Syntax ip pim neighbor-filter {access-list} To remove the restriction, use the no ip pim neighbor-filter {accesslist} command. Parameters access-list Enter the name of a standard access list. Maximum 16 characters. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. PIM-Source Specific Mode (PIM-SSM) 1561