Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 186

4 File Management This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as other file management commands. The commands in this chapter are supported by the Dell Networking OS on the C9000 switch. boot system Specify the location where the Dell Networking OS image used to boot the system is stored. C9000 Series Syntax Parameters boot system [gateway ip address | [rpm0 {default | primary | secondary [ftp: | system:{A:| B:} | tftp:] }] [rpm1 {default | primary | secondary [ftp: |system:{A:|B:} | tftp:]}] gateway ip-address rpm0 rpm1 default primary secondary ftp: system A: | B: tftp: Enter the IP address of the default next-hop gateway for the management subnet. Enter an IP address in dotted decimal format. Enter the keyword rpm0 to specify the route processor module 0. Enter the keyword rpm1 to specify the route processor module 1. Enter the keyword default to use the default Dell Networking OS image. Enter the keyword primary to use the primary Dell Networking OS image. Enter the keyword secondary to use the secondary Dell Networking OS image. Enter the keyword FTP: to retrieve the image from an FTP server: ftp://userid:password @host-ip/filepath. Enter A: or B: to boot one of the flash system partitions. Enter the keyword TFTP: to retrieve the image from a TFTP server: tftp://host-ip/filepath. 186 File Management