Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 184

Version 8.3.12.0 8.1.1.0 7.5.1.0 E-Series Description Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series. Original command. Usage Information You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time this command is issued, it replaces the previously configured address of the same family, IPv4 or IPv6. The no virtual-ip command takes an address/prefix-length argument, so that the desired address only is removed. If you enter the no virtual-ip command without any specified address, then both IPv4 and IPv6 virtual addresses are removed. Related Commands ip address - assigns a primary and secondary IP address to the interface. write Copy the current configuration to either the startup-configuration file or the terminal. C9000 Series Syntax Parameters write {memory | terminal} memory terminal Enter the keyword memory to copy the current running configuration to the startup configuration file. This command is similar to the copy running-config startup-config command. Enter the keyword terminal to copy the current running configuration to the terminal. This command is similar to the show running-config command. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) Description Introduced on the C9010. Introduced on the Z9500. 184 Control and Monitoring