Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 360

set level - specifies the OSPF area for route redistribution. set metric - specifies the metric value assigned to redistributed routes. set tag - specifies the tag assigned to redistributed routes. set next-hop To specify an IP address as the next hop, configure a filter. C9000 Series Syntax set next-hop ip-address To delete the setting, use the no set next-hop ip-address command. Parameters ip-address Specify an IP address in dotted decimal format. Defaults Not configured. Command Modes ROUTE-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information If you configure the set next-hop command, its configuration takes precedence over the neighbor next-hop-self command in the ROUTER BGP mode. If you configure the set next-hop command with the interface's IP address (either Loopback or physical), the software declares the route unreachable. 360 Access Control Lists (ACL)