Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1423

The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.1(0.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced support for OSPFv3 on the S4810 and Z9000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. network area Define which interfaces run OSPF and the OSPF area for those interfaces. C9000 Series Syntax network ip-address mask area area-id To disable an OSPF area, use the no network ip-address mask area areaid command. Parameters ip-address mask area-id Specify a primary or secondary address in dotted decimal format. The primary address is required before adding the secondary address. Enter a network mask in /prefix format. (/x) Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value range is from 0 to 65535. IP address format is dotted decimal format A.B.C.D. NOTE: If the area ID is smaller than 65535, it is converted to a decimal value. For example, if you use an area ID of 0.0.0.1, it is converted to 1. Command Modes ROUTER OSPF Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Open Shortest Path First (OSPFv2 and OSPFv3) 1423