Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 388

The summary-only parameter suppresses all advertisements. If you want to suppress advertisements to only specific neighbors, use the neighbor distribute-list command. In the show ip bgp command, aggregates contain an 'a' in the first column and routes suppressed by the aggregate contain an 's' in the first column. When an aggregate address is denied using a peer's outbound route-map, individual routes suppressed by the aggregate address are advertised to that peer. The attribute-map corresponding to an aggregate address is applied during the outbound update creation time; hence the value set in that attribute-map will not be shown in the output of the show ip bgp aggregate route command. bgp add-path Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones. C9000 Series Syntax Parameters bgp add-path [send | receive | both] path-count send receive both path-count Enter the keyword send to indicate that the system sends multiple paths to peers. Enter the keyword receive to indicate that the system accepts multiple paths from peers. Enter the keyword both to indicate that the system sends and accepts multiple paths from peers. (OPTIONAL) Enter the number paths supported. The range is from 2 to 64. Defaults Command Modes Disabled • ROUTER BGP • ROUTER BGP-address-family Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. 388 Border Gateway Protocol