Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1584

ip pim rp-candidate To send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group prefixes that are defined with the RP address to PIM BSR, configure a PIM router. C9000 Series Syntax ip pim rp-candidate {interface [priority]}[vrf vrf-name] To return to the default value, use the no ip pim rp-candidate {interface [priority]}[vrf vrf-name] command. Parameters interface Enter the following keywords and slot/port or number information: • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383. • For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a VLAN, enter the keyword vlan then a number from 1 to 4094. priority vrf vrf-name (OPTIONAL) Enter the priority used in Bootstrap election process. The range is zero (0) to 255. The default is 192. (OPTIONAL) Enter the keyword vrf followed by the name of the VRF. NOTE: Applies to specific VRF if input is provided, else applies to Default VRF. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.7(0.0) Description Introduced on the C9010. Added support for VRF. Introduced on the S6000-ON. 1584 PIM-Sparse Mode (PIM-SM)