Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1593

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.8.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Usage Information The following describes the show ip pim neighbor command shown in the following example. Field Neighbor address Interface Uptime/expires Ver Description Displays the IP address of the PIM neighbor. List the interface type, with either slot/port information or ID (VLAN or Port Channel), on which the PIM neighbor was found. Displays the amount of time the neighbor has been up then the amount of time until the neighbor is removed from the multicast routing table (that is, until the neighbor hold time expires). Displays the PIM version number. • v2 = PIM version 2 DR prio/Mode Displays the Designated Router priority and the mode. • 1 = default Designated Router priority (use the ip pim dr-priority command) • DR = Designated Router • S = Sparse mode Example Dell#show ip pim neighbor↵ Neighbor Interface Uptime/Expires Ver DR↵ Address Prio/Mode↵ 127.87.3.4 Te 1/16 09:44:58/00:01:24 v2 1 / S↵ PIM-Sparse Mode (PIM-SM) 1593