Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 583

Command History Version 9.9(0.0) 9.2(1.0) 8.2.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced Usage Information The TCP session is authentication and hence prevents the data from being compromised. network Specify the networks for the BGP process and enter them in the BGP routing table. C9000 Series Syntax network ipv6-address prefix-length [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. Parameters ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. The range is /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros. mask route-map mapname Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keywords route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version Description 9.9(0.0) Introduced on the C9010. Border Gateway Protocol 583