Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1650

Example When class mode is configured, maximum power for the particular class of device is allocated. Class mode supports power allocation via Layer 2 classification and power negotiation by Link Layer Discovery Protocol (LLDP) 802.3at standard . When static mode is configured, the inline power is allocated based on the actual power consumption by the powered device. Power negotiation via LLDP is not supported in static mode. The following examples show power management mode, "class" configured for the port extender 255. Dell(conf)#power inline mode pe 0 stack-unit 0 static Dell#show power inline pe 0 stack-unit 0 Global inline power Threshold : Power Reserved for inline Power: Total Inline Power Consumed: Remaining inline power Available: Power Management Mode: 99 841W 0W 841W Static Interface Inline Power Device PoE Port LLDP Max / Alloc Type Priority Support (Watts) PeGi 0/0/0 30.00/0.00 - low 0 Inline Power Consumed (Watts 0.00 Class ------NO_PD power inline restore pe Enable the temporarily suspended PoE power supply to all the ports in a port extender unit. C9000 Series Syntax Parameters power inline restore pe pe-id stack-unit unit number pe pe-id stack-unit unit number Enter the keyword pe and the port extender ID. Range is from 0 to 255. Enter the keyword stack-unit and the stack-unit number. Range is from 0 to 7. Defaults None Command Modes EXEC Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 1650 Port Extenders (PE)