Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 280

mask count bytes log order monitor fragments Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword log to include ACL matches in the log. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority) If you did not use the keyword order, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the Dell Networking OS Configuration Guide. Enter the keyword fragments to use ACLs to control packet fragments. Defaults Not configured. Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 8.2.1.0 8.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added the keyword dscp. Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on the E-Series ExaScale. 280 Access Control Lists (ACL)