Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1604

Version 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 8.4.2.0 7.7.1.0 Description Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series TeraScale. Introduced on the E-Series ExaScale. Usage Information You can apply any number of redirect-groups to an interface. A redirect list can contain any number of configured rules. These rules include the next-hop IP address where the incoming traffic is redirected. If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise, the normal routing table is used to forward traffic. When a redirectgroup is applied to an interface and the next-hop is reachable, the rules are added into the PBR CAM region. When incoming traffic hits an entry in the CAM, the traffic is redirected to the corresponding next-hop IP address specified in the rule. NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only. Related Commands • show cam pbr - displays the content of the PBR CAM. • show ip redirect-list - displays the redirect-list configuration. ip redirect-list Configure a redirect list and enter REDIRECT-LIST mode. C9000 Series Syntax ip redirect-list redirect-list-name ] To remove a redirect list, use the no ip redirect-list command. Parameters redirect-list-name Enter a description to identify the IP redirect list (16 characters maximum) Defaults None Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. 1604 Policy-based Routing (PBR)