Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1731

DSCP Color Map Commands The DSCP color map allows you to set the number of specific DSCP values to yellow or red. Traffic marked as yellow delivers traffic to the egress queue which will either transmit the packet if it has available bandwidth or drop the packet due to no ability to send. Traffic marked as red (high drop precedence) is dropped. dscp Sets the number of specific DSCP values for a color map profile to yellow or red. C9000 Series Syntax dscp {yellow | red} [list-dscp-values] To remove a color policy map profile, use the no dscp {yellow | red} [dscp-list] command. Parameters Yellow red dscp-list Enter the yellow keyword. Traffic marked as yellow delivers traffic to the egress queue which either transmits the packet if it has available bandwidth or drops the packet due to no ability to send. Enter the red keyword. Traffic marked as red is dropped. Enter a list of IP DSCP values. The dscp-list parameter specifies the full list of IP DSCP value(s) for the specified color. Each DSCP value in a list is separate values by commas - no spaces (1,2,3) or indicates a list of values separated by a hyphen (1-3). Range is 0 to 63. Defaults None Command Modes CONFIG-COLOR-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.5(0.0) Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000, S6000, S4820T, S4810, and MXL. Usage Information If the specified color-map does not exist, the Diffserv Manager (DSM) creates a color map and sets all the DSCP values to green (low drop precedence). The default setting for each DSCP value (0-63) is green (low drop precedence). This command allows setting the number of specific DSCP values to yellow or red. Quality of Service (QoS) 1731