Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1877

Related Commands AAAAB3NzaC1yc2EAAAABIwAAAIEAyB17l4gFp4r2DRHI vMc1VZd0Sg5GQxRV1y1X1JOMeO6Nd0WuYyzrQMM 4qJAoBwtneOXfLBcHF3V2hcMIqaZN+CRCnw/ zCMlnCf0+qVTd1oofsea5r09kS0xTp0CNfHXZ3NuGC q9Ov33m9+U9tMwhS8vy8AVxdH4x4km3c3t5Jvc= freedom@poclab4 Dell# ip ssh rsa-authentication (Config) - configures the RSA authorized keys. ssh Open an SSH connection specifying the hostname, username, encryption cipher, HMAC algorithm, port number, and version of the SSH client. C9000 Series Syntax Parameters NOTE: Some of the parameters in this command require licensing to access. For more information, contact your Dell Networking representative. ssh[vrf vrf-name] {hostname | ipv4 address | ipv6 address} [-c encryption cipher | -l username | -m HMAC algorithm | -p portnumber | -v {1 | 2}] vrf vrf-name (OPTIONAL) Enter the keyword vrf aand then the name of the VRF to specify the VRF used with the SSH session. NOTE: The VRF configured using this command has a higher precedence than the VRF configured using the ip ssh vrf vrf-name command. If you do not configure a VRF using this command, then the SSH client uses the configured VRF (if any). If there is a mismatch between VRFs that are configured using the ip ssh source-interface command and the ssh vrf vrf-name command, then an error is reported. hostname vrf instance ipv4 address ipv6-address prefix-length (OPTIONAL) Enter the IP address or the host name of the remote device. (OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF Instance name to open an SSH connection to that instance. (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D. (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x format. The range is from /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros. Security 1877