Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 260

Example Related Commands The number of entries allowed per ACL is hardware-dependent. For detailed information on the number entries allowed per ACL on the C9000, refer to the Content Addressable Memory (CAM) chapter in the C9000 Configuration Guide. Dell(conf)#ip access-list standard TestList Dell(config-std-nacl)# ip access-list extended - creates an extended access list. show config - displays the current configuration. permit Configure a filter to permit packets from a specific source IP address to be processed and forwarded to another interface on the switch. C9000 Series Syntax permit {source [mask]| any | host ip-address}[count [byte]] [dscp value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit {source [mask] | any | host ip-address} command. Parameters source mask any host ip-address count byte dscp order Enter the IP address in dotted decimal format of the network from which the packet was sent. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address. (OPTIONAL) Enter the keyword count to count packets that the filter processes. (OPTIONAL) Enter the keyword byte to count bytes that the filter processes. (OPTIONAL) Enter the keyword dcsp to match to the IP DSCP values. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 260 Access Control Lists (ACL)