Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1364

cpu rp ipv6-address ipv6-address NOTE: If you do not specify this option, neighbors corresponding to the default VRF are displayed. Enter the keywords cpu rp to display information about IPv6 neighbors learned only on the Route Processor. Enter the IPv6 address of a neighbor to display information about the specified device. Enter the IPv6 address of the neighbor in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zero. interface interface Enter the keyword interface then the interface type and slot/port or number information: Defaults Command Modes none • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.2(1.0) 9.0.0.0 8.3.19.0 8.3.11.1 8.3.7.1 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Added support for VRF. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information When you issue the show ipv6 neighbors without specifying any options, it will display all IPv6 neighbor addresses stored on the control processor (CP). Example Dell#show ipv6 neighbors * - Active session role Ad Dn - Admin Down B - BGP C - CLI 1364 Neighbor Discovery Protocol (NDP)