Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1948

Parameters To disable this command and return to the default setting, use the no logging source-interface command. interface Enter the following keywords and slot/port or number information: • For Loopback interfaces, enter the keyword loopback then a number from zero (0) to 16383. • For the management interface on the RPM, enter the keyword ManagementEthernet then the slot/port information. The slot range is from 0 to 1 and the port range is 0. • For a Port Channel interface, enter the keywords portchannel then a number. Tthe range is from 1 to 128. • For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For VLAN interface, enter the keyword vlan then a number from 1 to 4094. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.5.1.0 7.6.1.0 7.5.1.0 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for 4-port 40G line cards on ExaScale. Introduced on the S-Series. Introduced on the C-Series. Usage Information Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging source-interface command, the Syslog packets contain the IP address of the interface configured. Related Commands logging - enables logging to the Syslog server. 1948 Simple Network Management Protocol (SNMP) and Syslog