Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 957

interface port-channel Create a Port Channel interface, which is a link aggregation group (LAG) containing sixteen physical interfaces on the switch. C9000 Series Syntax interface port-channel channel-number To delete a Port Channel, use the no interface port-channel channelnumber command. Parameters channel-number For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.6.1.0 7.5.1.0 6.2.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on S4810. Introduced on Z9000. Introduced on E-Series ExaScale. Introduced on S-Series. Introduced on C-Series. Introduced on E-Series. Usage Information Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the switchport command) or Layer 3 mode (by configuring an IP address) with an exception that when the PE ports are configured as a member of Port Channel you can configure that Port Channel in Layer 2 mode (using the switchport command) and add it to a VLAN. The shutdown, description, and name commands are the only commands that you can configure on an interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the interface can only have the shutdown, Interfaces 957