Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 752

write-to Enter the location to save the captured packets. Files can be saved to flash, to FTP, SCP, or TFTP: • flash://filepath • ftp://userid:password@hostip/filepath • scp://userid:password@hostip/filepath • tftp://hostip/filepath Defaults TCP dumps are disabled. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information Use the tcpdump command to perform a packet capture on a specified switch CPU: Control Processor (CP) or Route Processor (RP). You can use the capture-duration timer and the packet-count counter at the same time. The TCP dump stops when the first of the thresholds is met. That means that even if the duration timer is 9000 seconds, if the maximum file count parameter is met first, the dumps stop. The files saved on the flash are located in the flash://TCP_DUMP_DIR/ Tcpdump_/directory. The file name is tcpdump_*.pcap. There can be up to 20 Tcpdump_ directories. If more than 20 files are created, the oldest is overwritten. Entering the no tcpdump command stops any TCP dump process running in either the Control Processor or Route Processor. The dump stops immediately, without waiting for a threshold to be met. To stop the TCP dump process running in the CP processor, enter the no tcpdump cp command; to stop the TCP dump process running in the RP processor, enter the no tcpdump rp command. 752 Debugging and Diagnostics