Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 256

Usage Information show ip accounting access-lists Field "Extended IP..." "seq 5..." "order 4" Description Displays the name of the IP ACL. Displays the filter. If the keywords count or byte were configured in the filter, the number of packets or bytes the filter processes is displayed at the end of the line. Displays the QoS order of priority for the ACL entry. Example Dell#show ip accounting access FILTER1 interface tengig 1/6 Extended IP access list FILTER1 seq 5 deny ip any 191.1.0.0 /16 count (0x00 packets) seq 10 deny ip any 191.2.0.0 /16 order 4 seq 15 deny ip any 191.3.0.0 /16 seq 20 deny ip any 191.4.0.0 /16 seq 25 deny ip any 191.5.0.0 /16 Standard IP ACL Commands When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit. The C9000 supports both Ingress and Egress IP ACLs. NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections. deny Configure a filter that drops IP packets meeting the filter criteria. C9000 Series Syntax deny {source mask | any | host ip-address} [count [byte] | [dscp value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {source [mask] | any | host ip-address} command. Parameters source Enter the IP address of the network or host from which the packets were sent. 256 Access Control Lists (ACL)