Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1434

Example Related Commands The following describes the show ip ospf command shown in the following example. Line Beginning Description with "Routing Process..." Displays the OSPF process ID and the IP address associated with the process ID. "Supports only..." Displays the number of Type of Service (TOS) rouse supported. "SPF schedule..." Displays the delay and hold time configured for this process ID. "Convergence Level" "Min LSA...." Displays the intervals set for LSA transmission and acceptance. "Number of..." Displays the number and type of areas configured for this process ID. Dell#show ip ospf 10 Routing Process ospf 10 with ID 1.1.1.1 Virtual router default Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 0 Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0 Area BACKBONE (0) Number of interface in this area is 1 SPF algorithm executed 205 times Area ranges are Dell# show ip ospf database - displays information about the OSPF routes configured. show ip ospf interface - displays the OSPF interfaces configured. show ip ospf neighbor - displays the OSPF neighbors configured. show ip ospf asbr Display all autonomous system boundary router (ASBR) routers visible to OSPF. C9000 Series Syntax Parameters show ip ospf process-id | vrf vrf-name asbr process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. 1434 Open Shortest Path First (OSPFv2 and OSPFv3)