Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1137

Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.7.0 8.1.1.2 8.1.1.0 7.9.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the E-Series ExaScale E600i. Introduced on the E-Series ExaScale. Introduced VRF on the E-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ip cam command shown in the following example. Field Index Destination EC CG V Description Displays the CAM index number of the entry. Displays the destination route of the index. Displays the number of equal cost multipaths (ECMP) available for the default route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is more than eight. Displays 0. Displays a 1 if the entry is valid and a 0 if the entry is for a line card with Catalog number beginning with LC-EF. C Next-Hop VId Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the CP or RP2, depending on Egress port. Displays the next hop IP address of the entry. Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN. Mac Addr Displays the next-hop router's MAC address. Port Displays the egress interface. Use the second half of the entry to determine the interface. For example, in the entry 17cl CP, the CP is the pertinent portion. • CP = control processor IPv4 Routing 1137