Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1056

• For a port channel interface, enter the keywords portchannel then a number. Defaults Disabled. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 E-Series legacy command Description Introduced on the C9010. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information IGMP commands accept only non-VLAN interfaces - specifying VLAN does not yield results. This command displays packets for IGMP and IGMP snooping. ip igmp access-group Specify access control list for packets in access-group. C9000 Series Syntax ip igmp access-group access-list To remove the feature, use the no ip igmp access-group access-list command. Parameters access-list Enter the name of the extended ACL (16 characters maximum). Defaults Not configured Command Modes INTERFACE (conf-if-interface-slot/port) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. 1056 Internet Group Management Protocol (IGMP)